BNRZF - NCFI 584-2.5, URETHANE RESIN

Product Identification

Product ID:NCFI 584-2.5, URETHANE RESIN
MSDS Date:11/13/1985
FSC:8040
NIIN:00N030628
MSDS Number: BNRZF

Responsible Party
NORTH CAROLINA FOAM INDUSTRIES INC
MOUNT AIRY, NC 27030
US

Emergency Phone: 919-789-9161

Info Phone: 919-789-9161

Cage: 3T135

Contractor
NORTH CAROLINA FOAM INDUSTRIES INC
MOUNT AIRY, NC 27030 US

Telephone: 919-789-9161

Cage: 3T135

Ingredients

75F, 24C.

CAS: 75-69-4

RTECS: PB6125000

Fraction By Weight: <25%

OSHA PEL 1000 PPM

ACGIH TLV: C, 1000 PPM; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


TERTIARY AMINE CATALYST

Fraction By Weight: <2%

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:CHLOROCARBON/CHLOROFLUOROCARBON (CFC)
MATLS HAVE PRDCED SENSIT OF THE MYOCARDIUM TO EPINEPHRINE IN LAB
ANIMALS & COULD HAVE A SIMILAR EFT IN HUMANS.ADRENOMIMETICS (E.G.,
EPINEPHRINE) MAY BE CONTRAINDI CATED EXCEPT FOR LIFE-SUSTAINING
USES IN HUMANS ACUTELY/ CHRONICALLY EXPOS TO CHLOROCARBONS/CFC'S
(EFTS OF OVEREXPOS)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: . MAY CAUSE SKIN/EYE IRRITATION UPON
CONTACT. AVOID BREATHING VAPORS. THE DENSE VAPORS CAN DISPLACE AND
REDUCE BREATHING AIR IN CONFINED OR UNVENTILATED SPACES. AT LEVELS
ABOVE THE TLV , CFCL3, ACTS AS A WEAK NARCOTIC. OVEREXPOSURE CAUSES
TREMORS, CONFUSION, IRRITATION, AND MAY RESULT IN CARDIAC SENSIT.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. SEE MD IF
IRRITATION DEVELOPS. SKIN: WASH WITH SOAP AND WATER AT FIRST
OPPORTUNITY. INHAL: MOVE TO FRESH AIR IF SYMPTOMS DEVELOP. IF
BREATHING IS DIFFIC ULT, GIVE OXYGEN AND CALL MD. INGEST: INDUCE
VOMITING, GET MEDICAL ATTENTION.

Fire Fighting

Flash Point Method:PMCC
Flash Point:SUPP DATA
Extinguishing Media:WATER, DRY CHEMICALS, CO2.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED PRESSURE DEMAND SCBA
AND FULL PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:THERMAL DECOMP PRODS MAY INCL CHLORIDES,
FLUORIDES & PHOSGENE . OVERHEATED CNTNRS MAY RUPTURE DUE TO PRESS
PRDCED BY CFCL3. CFCL3 DECOMPOSES (SUPP DATA)

Accidental Release

Spill Release Procedures:CONTAIN SPILL. ABSORB WITH SAWDUST, ETC., AND
SHOVEL INTO CONTAINER. WASH AREA WITH DETERGENT AND WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE BETWEEN 65-85F OUT OF SUNLIGHT.
KEEP TIGHTLY SEALED. RELIEVE PRESSURE SLOWLY WHEN OPENING
CONTAINER. AVOID EYE AND SKIN CONTACT.
Other Precautions:R COMPONENT DRUMS CAN BE SENT TO DRUM RECONDITIONERS/
DISPOS OF AS ORDINARY INDUST WASTE IN COMPLIANCE W/PERTINENT
REGS.NO SMOKING IN AREA OF USE. DO NOT USE IN GEN VICINITY OF ARC
WELDING, OPEN FLAME S/HOT SURFS. HEAT AND/OR (SUPP DATA)

Exposure Controls

Respiratory Protection:IF VAPORS ARE GENERATED, WEAR A NIOSH/MSHA
APPROVED ORGANIC VAPOR RESPIRATOR. ALSO WEAR A NIOSH/MSHA APPROVED
RESPIRATOR WHEN MIXED WITH A COMPONENT WHICH IS ISOCYANATE.
Ventilation:PROVIDE LOCAL EXHAUST TO STAY BELOW TLV.
Protective Gloves:CHEMICALLY RESISTANT RUBBER OR PLASTIC.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYE WASH SYSTEM AND SHOWERS SHOULD BE
AVAILABLE.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FL PT: AFTER CFCL3 EVAPORATION, OVER 200F. EXPLO HAZ: TO FORM ACIDS AND
NOXIOUS GASES WHEN BURNED. OTHER PREC: UV RADIATION MAY CAUSE THE
FORMATION OF CHLORIDES, FLUORIDES OR PHOSGENE . CAUTION: UNDER NO
CIRCUMSTANCE SHOULD EMPTY DRUMS BE BURNED TO CUT OPEN WITH AN
ELECTRIC OR GAS TORCH.

Chemical Properties

HCC:T6
Boiling Pt:B.P. Text:SEE ING 1
Spec Gravity:1.23
Solubility in Water:SLIGHT
Appearance and Odor:DARK LIQUID; FAINT ETHEREAL ODOR.
Percent Volatiles by Volume:<20

Stability

Stability Indicator/Materials to Avoid:YES
ISOCYANATES AND OTHER CHEMICALS WHICH REACT WITH HYDROXYL GROUPS.
Stability Condition to Avoid:TEMPERATURES OVER 85F.
Hazardous Decomposition Products:CHLORIDES, FLUORIDES AND PHOSGENE .
WHEN BURNED: CO, CO2, NO2, ALIPHATIC FRAGMENTS, HF, HCL.

Disposal

Waste Disposal Methods:WASTE MATERIAL SHOULD BE DISPOSED OF UNDER
CONDITIONS WHICH MEET FEDERAL, STATE AND LOCAL ENVIRONMENTAL
CONTROL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.